Apple Optical Drive Bracket Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Stojany Apple Optical Drive Bracket. Apple Optical Drive Bracket User's Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 6
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
073-0702 Rev. A
ð
Xserve
Optical Drive Bracket
Replacement Instructions
Follow the instructions in this sheet carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Note:
Online instructions covering customer-installable parts are available at
http://www.info.apple.com/installparts/.
Tools Required
The following tools are required for this procedure:
•Flatblade screwdriver
•Phillips screwdriver
Opening the Server
The server slides open from the front of the rack. The top cover remains in place in the
rack while the bottom housing (containing all internal components) should be placed on a
sturdy, flat surface.
1.Alert users that the server will be unavailable for a period of time.
2.Shut down the server.
Warning: To avoid damaging internal components or causing injury, always
shut down the server before opening it. After you shut down the server, internal
components can be very hot. Let the server cool down before continuing.
3.Write down the server’s serial number, which is located on the back panel. If it is
necessary to set up the server’s software after you replace the optical drive bracket,
you will be asked for the serial number at login.
Zobrazit stránku 0
1 2 3 4 5 6

Shrnutí obsahu

Strany 1 - Optical Drive Bracket

073-0702 Rev. A ð Xserve Optical Drive Bracket Replacement Instructions Follow the instructions in this sheet carefully. Failure to follow these in

Strany 2

Xserve Optical Drive Bracket - 2 4. If the server is in the locked position (the yellow security LED on the front panel is on), use the Allen key th

Strany 3

Xserve Optical Drive Bracket - 3 9. Grasp the thumbscrews and slide the bottom housing forward part way to expose the two chassis levers. (Figure 2

Strany 4

Xserve Optical Drive Bracket - 4 Removing the Installed Optical Drive Bracket 1. Disconnect the optical drive cable from the optical drive. (Figure

Strany 5 - Closing the Server

Xserve Optical Drive Bracket - 5 Installing the Replacement Optical Drive Bracket 1. Install the replacement bracket on the drive, securing it with

Strany 6

Xserve Optical Drive Bracket - 6 ð Apple Computer, Inc. © 2002 Apple Computer, Inc. All rights reserved.This document is protected under U.S. Copy

Komentáře k této Příručce

Žádné komentáře