Apple Dual-Slot Riser Card Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro ne Apple Dual-Slot Riser Card. Apple Dual-Slot Riser Card User's Manual [en] Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 5
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
073-0688 Rev. B
Xserve
Dual-Slot Riser Card
Replacement Instructions
Follow the instructions in this sheet carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Note:
Online instructions covering customer-installable parts are available at
http://www.info.apple.com/installparts/.
Tools Required
No tools are required for this procedure. You may, however, find a Phillips screwdriver
useful in releasing the thumbscrews at the front of the server.
Opening the Server
The server slides open from the front of the rack. The top cover remains in place in the
rack while the bottom housing (containing all internal components) should be placed on a
sturdy, flat surface.
1. Alert users that the server will be unavailable for a period of time.
2. Shut down the server.
Warning: To avoid damaging internal components or causing injury, always
shut down the server before opening it. After you shut down the server, internal
components can be very hot. Let the server cool down before continuing.
3. Write down the server’s serial number, which is located on the back panel. If it is
necessary to set up the server’s software after you replace a dual-slot riser card, you
will be asked for the serial number at login.
Zobrazit stránku 0
1 2 3 4 5

Shrnutí obsahu

Strany 1 - Dual-Slot Riser Card

073-0688 Rev. B  Xserve Dual-Slot Riser Card Replacement Instructions Follow the instructions in this sheet carefully. Failure to follow these ins

Strany 2

Xserve Dual-Slot Riser Card - 2 4. If the server is in the locked position (the yellow security LED on the front panel is on), use the Allen key tha

Strany 3

Xserve Dual-Slot Riser Card - 3 9. Grasp the thumbscrews and slide the bottom housing forward part way to expose the two chassis levers. (Figure 2)

Strany 4

Xserve Dual-Slot Riser Card - 4 Removing the Dual-Slot Riser Card 1. Release the thumb screw that secures the riser’s cards to the server. (Figure

Strany 5 - Closing the Server

Xserve Dual-Slot Riser Card - 5 Installing the Replacement Dual-Slot Riser Card 1. Install the PCI card(s) in the replacement riser card. 2. Reconne

Komentáře k této Příručce

Žádné komentáře