Apple Optical Drive Cable Uživatelský manuál stáhnout pdf

073-0677 Rev. A

Xserve

Optical Drive Cable

Replacement Instructions

Follow the instructions in this sheet carefully. Failure to follow these instructions could

damage your equipment and void its warranty.

Note:

Online instructions covering customer-installable parts are available at

http://www.info.apple.com/installparts/.

Tools Required

No tools are required for this procedure. You may, however, ﬁnd a Phillips screwdriver

useful in releasing the thumbscrews at the front of the server.

Opening the Server

The server slides open from the front of the rack. The top cover remains in place in the

rack while the bottom housing (containing all internal components) should be placed on a

sturdy, ﬂat surface.

1. Alert users that the server will be unavailable for a period of time.

2. Shut down the server.

Warning: To avoid damaging internal components or causing injury, always

shut down the server before opening it. After you shut down the server, internal

components can be very hot. Let the server cool down before continuing.

3. Write down the server’s serial number, which is located on the back panel. If it is

necessary to set up the server’s software after you replace the optical drive cable, you

will be asked for the serial number at login.

1 2 3 4 5

073-0677 Rev. A ð Xserve Optical Drive Cable Replacement Instructions Follow the instructions in this sheet carefully. Failure to follow these inst

Xserve Optical Drive Cable - 2 4. If the server is in the locked position (the yellow security LED on the front panel is on), use the Allen key that

Xserve Optical Drive Cable - 3 9. Grasp the thumbscrews and slide the bottom housing forward part way to expose the two chassis levers. (Figure 2)

Xserve Optical Drive Cable - 4 Removing the Installed Optical Drive Cable 1. Disconnect the optical drive cable from the optical drive.2. Disconnect

Žádné komentáře

Apple Optical Drive Cable Uživatelský manuál