Apple eMac (Stand Installation) Uživatelský manuál

073-0704 Rev. C  eMac Computers Stand Installation Installing the Optional Stand Follow the instructions for the type of eMac that you have. The p

Stand Installation - 10 8. Position the stand in place over the screw holes. 9. Note: The stand slides back and forth. To attach the first screw,

Stand Installation - 11 10. Push the stand forward. Tighten the second screw.11. Tighten the third screw.

Stand Installation - 12 12. Carefully turn the computer over.

Stand Installation - 13  Apple Computer, Inc. © 2004 Apple Computer, Inc. All rights reserved.This document is protected under U.S. Copyright La

Stand Installation - 2 eMac Installation Procedure To install the eMac stand: 1. Save open documents and quit all open applications. 2. Turn the co

Stand Installation - 3 6. The stand attaches to the locations circled below. 7. Remove the screw located between the computer’s feet.

Stand Installation - 4 8. Position the stand on top of the screw holes. 9. Note: The stand slides back and forth. To attach the first screw, slide

Stand Installation - 5 10. Tighten the first screw.11. Slide the stand forward to access the two rear screws.

Stand Installation - 6 12. Tighten the screw on the left. 13. Tighten the screw on the right.

Stand Installation - 7 14. Carefully turn the computer over.

Stand Installation - 8 eMac (ATI Graphics) and eMac (USB 2.0) Installation Procedure To install the eMac (ATI Graphics) or eMac (USB 2.0) stand: 1.

Stand Installation - 9 6. The stand attaches to the locations circled below. 7. Remove the screw circled below.