Apple iMac Uživatelský manuál stáhnout pdf



iMac (Flat Panel, 1GHz) and iMac (USB 2.0)

Memory, SO-DIMM Installation

Instructions

Follow the instructions in this sheet carefully. Failure to follow these instructions could

damage your equipment and void its warranty.

Note:

This computer uses double-data rate (DDR) memory. Memory from previous iMac

models is not compatible with this computer. Do not use older SO-DIMMs even if they fit

into the slot. Memory used in this slot should be low-proﬁle PC2100 (DDR266) SO-

DIMM for the 17-inch 1 GHz and PC2700 (DDR333) for the iMac (USB 2.0) models.

Written and video instructions covering customer-installable parts are available at http://

www.info.apple.com/installparts/.

Tools Required

• #1 Phillips screwdriver

• Soft cloth

Opening the Computer

Warning: Always shut down your computer before opening it to avoid damaging its

internal components or causing injury.

1. Unplug all cables from the computer except the power cord.

2. Supporting the neck and the base, lay the computer down on a soft cloth as shown in

Figure 1.

Figure 1

1 2 3 4 5 6

 iMac (Flat Panel, 1GHz) and iMac (USB 2.0) Memory, SO-DIMM Installation Instructions Follow the instructions in this sheet carefully. Failure to

iMac (Flat Panel, 1 GHz) and iMac (USB 2.0) Memory - 2 3. Loosen the four captive screws at the base of the computer and gently remove the access pa

iMac (Flat Panel, 1 GHz) and iMac (USB 2.0) Memory - 3 5. Warning: Do not remove the screws on the bottom housing (Figure 4). Loosening these

iMac (Flat Panel, 1 GHz) and iMac (USB 2.0) Memory - 4 Installing the Memory Module This computer uses double-data rate (DDR) memory. Memory from pr

iMac (Flat Panel, 1 GHz) and iMac (USB 2.0) Memory - 5 Closing the Computer 1. Replace the access panel and tighten the four captive screws (Figure

Další dokumenty pro Počítače Apple iMac

Apple iMac Uživatelský manuál (76 stránky)

Apple iMac Uživatelský manuál (32 stránky)

Žádné komentáře