Apple Power Macintosh G3 Minitower Technické informace stáhnout pdf (Strana 28)

Connecting video equipment for output from the computer

You can connect a VCR to record computer images and audio on videotape. The VCR records

what is happening on the computer’s monitor, sounds generated by the computer, and

speech spoken into a microphone if one is connected. This capability is useful for creating

video presentations or software demonstrations.

Note: The video out ports are primarily intended for recording what is happening on the

computer’s monitor. You can use video-editing software to save captured and edited video

on a VCR if the video-editing software supports the use of a single monitor. However, to get

full video-editing support with independent monitor and video (or TV) output, you need to

purchase and install a third-party video capture PCI card.

To connect a VCR for output from the computer, do the following:

1 Shut down the Macintosh and turn off the VCR.

2 Attach one end of the video cable to the Video In port on the VCR.

Follow the directions that came with the VCR.

3 Plug the other end of the video cable into either the S-video output port (Æ) or the yellow

composite video output port (Â) on the Macintosh.

If the S-video connector doesn’t slide easily into the port, check the pin alignment and try

again. Don’t use force, which could damage the computer or cable.

4 Plug the RCA-type connectors on the audio cables into the left and right Audio In ports on

the VCR.

5 Plug the RCA-type connectors on the audio cables into the left and right audio output ports

(-) on the Macintosh.

If the cable is color-coded, the red connector is for the right port, and the black or white

connector is for the left port.

28 Chapter 2

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 87 88

Žádné komentáře

Apple Power Macintosh G3 Minitower Technické informace Strana 28