Apple Xserve Up Mac OS X Server Specifikace stáhnout pdf (Strana 107)

Chapter 8 Managing User and Group Accounts 107

To terminate a user’s processes:

After disabling the user account, you need to kill the user’s active processes that are

running on the directory server.

1 Make all processes clean up and exit by entering the following command, replacing

ajohnson with the user name:

$ sudo killall -TERM -u

ajohnson

2 Wait a few seconds to allow the previous command to execute; then, to terminate the

user’s processes, enter the following command, replacing ajohnson with the user name:

$ sudo killall -9 -u

ajohnson

For more information about terminating processes, see the killall man page.

To reenable a disabled user account:

m Enable the user account by entering the following command.

$ pwpolicy -a

diradmin

-u

ajohnson

-setpolicy “isDisabled=0”

Replace ajohnson with the short name of the user account and replace diradmin with

the short name of your domain administrator account.

Verifying a Server User’s Name, UID, or Password

To verify the name, UID, or password of a user in the server’s local directory domain,

use the following commands.

Note: These tasks apply only to the local directory domain on the server.

To see if a full name is in use:

$ sudo /System/Library/ServerSetup/serversetup -verifyRealName "

longname

The command displays a 1 if the name is in use, or a 0 if it isn’t.

To see if a short name is in use:

$ sudo /System/Library/ServerSetup/serversetup -verifyName

shortname

The command displays a 1 if the name is in use, or a 0 if it isn’t.

To see if a UID is in use:

$ sudo /System/Library/ServerSetup/serversetup -verifyUID

uid

The command displays a 1 if the UID is in use, or a 0 if it isn’t.

WARNING: Unconditionally killing a user’s processes causes the user to lose unsaved

data.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 328 329

Žádné komentáře

Apple Xserve Up Mac OS X Server Specifikace Strana 107