Apple Xserve Intel (Late 2006) DIY Procedure for Process Uživatelský manuál

 Xserve (Late 2006)073-1097 Rev. AProcessorReplacement InstructionsFollow the instructions in this document carefully. Failure to follow these instru

Xserve (Late 2006) Processor Replacement Instructions 10Replacing the Airow DuctLower the airow duct into position on the logic board. Note: When i

Xserve (Late 2006) Processor Replacement Instructions 11Closing the XserveReplace and secure the cover.Slide the Xserve back into the rack, and tight

Xserve (Late 2006) Processor Replacement Instructions 2Warning: Always shut down the Xserve before opening it to avoid damaging its internal componen

Xserve (Late 2006) Processor Replacement Instructions 3Opening the XserveLoosen the thumbscrews at the back of the top cover and slide the cover back

Xserve (Late 2006) Processor Replacement Instructions 4Caution: Try not to completely remove the screws from the airow duct. Tiny black rubber washe

Xserve (Late 2006) Processor Replacement Instructions 5Important: Each heat sink is connected to the logic board by a small 2-pin thermal sensor cabl

Xserve (Late 2006) Processor Replacement Instructions 6ProcessorRelease the latch on the metal processor holder.Rotate the top of the holder to the o

Xserve (Late 2006) Processor Replacement Instructions 7Installing the Replacement ProcessorNote: You will need to apply new thermal grease to the top

Xserve (Late 2006) Processor Replacement Instructions 8Holding the processor by its edges only, place the processor into its holder on the logic boar

Xserve (Late 2006) Processor Replacement Instructions 9Replacing the Processor Heat SinkHolding the heat sink in one hand, reconnect the 2-pin therma