Apple PC Serial and Parallel Card Uživatelský manuál stáhnout pdf (Strana 14)

What you need

Before beginning the installation process, make sure you have all the

necessary parts: the PC Serial and Parallel Card and the peripheral flex cable.

Yo u’ ll also need a Phillips screwdriver, your PC Compatibility Card user’s

manual, and a magazine that you can place the computer’s logic board on.

Installing the PC Serial and Parallel Card hardware

There are several steps to installing your PC Serial and Parallel Card

hardware:

m opening the computer

m preparing the slots

m attaching the peripheral flex cable to the PC Compatibility Card

m inserting the PC Serial and Parallel Card

m attaching the peripheral flex cable to the PC Serial and Parallel Card

m replacing the logic board

WARNING

The installation of the PC Serial and Parallel Card is

technically complex. Unless you are comfortable installing components

inside computers, Apple recommends that you have the PC Serial and

Parallel Card installed by your Apple-authorized dealer (who may

charge a fee). If you attempt to install the card yourself, any damage you

may cause to your equipment will not be covered by the limited

warranty on your computer.

Do not attempt to install the card or connect the cables without first

reading this manual.

Chapter 2

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 83 84

Žádné komentáře

Apple PC Serial and Parallel Card Uživatelský manuál Strana 14