Apple Xserve (Early 2008) DIY Procedure for Logic Board Uživatelský manuál stáhnout pdf (Strana 20)

Xserve (Late 2006/Early 2008) Logic Board Replacement Instructions 20

Installing the Replacement Logic Board

Important: When replacing the logic board, make sure the board’s rear port connectors t

through the appropriate openings in the Xserve’s back panel. Take special care to t the clear

plastic system identier button through its opening. Don’t bend or ex the logic board.

With the front edge of the board raised 1–2 inches (3–5 cm), guide the connectors on the 1.

back edge of the board into the openings in the back panel of the enclosure, and then lower

the front edge of the board into place.

Remove the battery insulator tab from the battery holder on the replacement logic board.2.

Note: Depending on the Xserve model, the battery position may dier from what is shown.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 30 31

Žádné komentáře

Apple Xserve (Early 2008) DIY Procedure for Logic Board Uživatelský manuál Strana 20