Apple Xserve (Early 2008) DIY Procedure for Logic Board Uživatelský manuál Strana 28

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 31
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 27
Xserve (Late 2006/Early 2008) Logic Board Replacement Instructions 28
Tighten the ve Phillips screws that fasten the airow duct to the fan array, in the order 3.
shown, to prevent the duct from warping. Do not overtighten the screws.
Replacing the FB-DIMMs
Important: Be sure to install each FB-DIMM in the slot on the replacement board that is
equivalent to the slot you removed it from on the original logic board.
Align the rst FB-DIMM with its slot and press down until the latches snap back up into 1.
place.
Note: The FB-DIMM is designed to t into the slot only one way. Be sure to align the notch in
the FB-DIMM with the small rib inside the slot.
Repeat for the remaining FB-DIMMs.2.
Zobrazit stránku 27
1 2 ... 23 24 25 26 27 28 29 30 31

Komentáře k této Příručce

Žádné komentáře