Apple Xserve (Early 2008) DIY Procedure for Rear ID Butt Uživatelský manuál stáhnout pdf (Strana 3)

Xserve (Late 2006/Early 2008) Rear ID Button Replacement Instructions 3

Removing the Installed Rear ID Button

Note: Before you can remove the rear ID button, you must rst remove the right PCI riser card

and any installed expansion card.

Right PCI Riser Card

Loosen the two captive screws that secure the right riser bracket to the back panel.1.

Carefully pull up on the right bracket and riser to disconnect the riser from the logic board. If 2.

an expansion card is installed in the riser, leave it attached.

Tilt the expansion card up so that its port clears the enclosure, and remove the riser and card 3.

from the Xserve.

Rear ID Button

Locate the rear ID button. 1.

1 2 3 4 5

Žádné komentáře

Apple Xserve (Early 2008) DIY Procedure for Rear ID Butt Uživatelský manuál Strana 3