Apple Xserve (Early 2008) DIY Procedure for Enclosure Uživatelský manuál stáhnout pdf (Strana 135)

Xserve (Late 2006/Early 2008) Logic Board Replacement Instructions 25

Rotate the top of the holder to the closed position.5.

Engage the latch on the processor holder. Repeat the steps above for the second processor.6.

Replacing the Processor Heat Sinks

Holding the heat sink by the slotted sides in one hand, reconnect the 2-pin thermal sensor 1.

cable for the heat sink to the logic board.

Note: Make sure the connector on the sensor cable is oriented as shown, with the gold

ngers facing up.

Carefully seat the heat sink over the processor, aligning the four screws with the holes in the 2.

logic board.

Tighten the four captive Phillips mounting screws for the heat sink in the order indicated 3.

below. Do not over-tighten the screws. If you have a torque driver, tighten the screws to 8

inch-pounds; otherwise, try to tighten the screws with equal pressure.

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 168 169

Žádné komentáře

Apple Xserve (Early 2008) DIY Procedure for Enclosure Uživatelský manuál Strana 135