Apple Xserve (Early 2008) DIY Procedure for Enclosure Uživatelský manuál stáhnout pdf (Strana 159)

Xserve (Late 2006/Early 2008) Rear ID Tab Replacement Instructions 18

Installing the Replacement Rear ID Tab

Insert the replacement rear ID tab through its slot in the rear panel. Make sure the tab engages

with the channel that it slides along in the enclosure.

Replacing the Logic Board

Important: When replacing the logic board, make sure the board’s rear port connectors t

through the appropriate openings in the Xserve’s back panel. Take special care to t the rear ID

button through its opening. Don’t bend or ex the logic board.

With the front edge of the board raised 1–2 inches (3–5 cm), guide the connectors on the 1.

back edge of the board into the openings in the back panel of the enclosure, and then lower

the front edge of the board into place.

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 168 169

Žádné komentáře

Apple Xserve (Early 2008) DIY Procedure for Enclosure Uživatelský manuál Strana 159