Apple Xserve (Early 2008) DIY Procedure for Enclosure Uživatelský manuál stáhnout pdf (Strana 3)

Xserve (Late 2006/Early 2008) Enclosure Replacement Instructions 3

Opening the Xserve

Loosen the thumbscrews at the back of the top cover and slide the cover back and up to remove

it. If you have diculty removing the cover, check the enclosure lock on the front panel.

Warning: Even after you shut down the Xserve, its internal components can be very hot. Let

it cool before you open it.

Important: To minimize the possibility of damage to Xserve components due to static discharge,

wear an antistatic wrist strap, if possible, while you work inside the Xserve.

Unscrew the two

captive thumbscrews.

Slide the cover back and lift it off.

Replacing the Enclosure

Note: Because you must remove both processor heat sinks during this procedure, you must

replace the thermal grease on both processors when reassembling the Xserve. New grease and

alcohol wipes for cleaning o the previous grease are supplied with the replacement enclosure.

Replacing the enclosure involves transferring the following parts from the original enclosure to

the replacement enclosure:

Both power supplie• s

All Apple drive modules•

Optical drive•

PCI riser cards and any expansion cards in both slot• s

Airow duc• t

Fan arra• y

Front panel board cabl• e

Backplane-to-logic board I/O cabl• e

Optical drive cabl• e

Locking mechanism rod•

Front panel boar• d

Drive interconnect backplan• e

Power distribution board cabl• e

Power distribution boar• d

Both processor heat sink• s

Logic boar• d

ID ta• b

1 2 3 4 5 6 7 8 ... 168 169

Žádné komentáře

Apple Xserve (Early 2008) DIY Procedure for Enclosure Uživatelský manuál Strana 3