Apple Xserve (Early 2008) DIY Procedure for Enclosure Uživatelský manuál stáhnout pdf (Strana 164)

Xserve (Late 2006/Early 2008) Rear ID Tab Replacement Instructions 23

Note: When installing the processor on the logic board, align the processor notch with the

tab on the processor holder, as shown. Then lower the processor straight down onto the

socket.

Rotate the top of the holder to the closed position.8.

Engage the latch on the metal processor holder. Repeat the steps above for the second 9.

processor.

Holding the heat sink by the slotted sides in one hand, reconnect the 2-pin thermal sensor 10.

cable for the heat sink to the logic board.

Note: Make sure the connector on the sensor cable is oriented as shown, with the gold

ngers facing up.

1 2 ... 159 160 161 162 163 164 165 166 167 168 169

Žádné komentáře

Apple Xserve (Early 2008) DIY Procedure for Enclosure Uživatelský manuál Strana 164