Apple Xserve Intel (Late 2006) DIY Procedure for Logic B Uživatelský manuál stáhnout pdf (Strana 21)

Xserve (Late 2006) Logic Board Replacement Instructions 21

Replacing the Fan Array

Align the power connector on the fan array with its connector on the power distribution

board and lower the array into the enclosure. Push down on the fan array power connector

to make sure it is fully seated.

Tighten the screws at the ends of the array. Make sure the large front panel board cable runs

above the power connector but below the tab on the top of the power supply.

Replacing the Airow Duct

Lower the airow duct into position on the replacement logic board.

Note: When installing the airow duct, be sure to route both the front panel board cable and

the backplane-to-logic board I/O cable inside the channel under the left side of the duct.

Ensure the airow duct ts ush all over, and does not protrude above the level of the

enclosure.

Note: Be careful when working with any black foam pieces that are part of the airow duct

or the logic board.

1 2 ... 16 17 18 19 20 21 22 23 24 25

Žádné komentáře

Apple Xserve Intel (Late 2006) DIY Procedure for Logic B Uživatelský manuál Strana 21